Im using the Tcl/Tk unitility to export an intelligent pdf of my schematic. (Allegro Design Entry CIS 16.6 on Windows7 64 bit)
I've got all the paths set correctly
Postscript Drier:PDFCreator
PS to PDF Converter Ghostscript
Windows pop up during the coversion. The first ones are too fast to read but I assume they are the conversion to postscript. Then a second window pops up saying "Printing file on the and the PDFCreator on PDFCreator Page #" where # increments. The utility finishes successfully. However when I look in my destination folder there is no pdf there.
Any idea what is going on? I've copied my output log below.
(::capPdfUtil::printPdf) Output Directory : N:/Electronics/dtra3_array/dtra3_array_ver3 Output File : DTRA3_ARRAY_VER3.pdf
(::capPdfUtil::printPdf) Annotating page objects for SCHEMATIC2 : CONNECTOR
(::capPdfUtil::printPdf) Annotating page objects for SCHEMATIC2 : SOLOMON READOUT
(::capPdfUtil::printPdf) Annotating page objects for SCHEMATIC2 : VOLTAGE REFERENCES
(::capPdfUtil::printPdf) Annotating page objects for SCHEMATIC2 : XCHIP_READOUT
(::capPdfUtil::printPdf) Annotating page objects for SOLOMONWIRE : SOLOMONWIRE
(::capPdfUtil::printPdf) Annotating page objects for SOLOMONWIRE : SOLOMONWIRE
(::capPdfUtil::printPdf) Annotating page objects for SOLOMONWIRE : SOLOMONWIRE
(::capPdfUtil::printPdf) Annotating page objects for XCHIP1 : XCHIP1
(::capPdfUtil::printPdf) Annotating page objects for XCHIP1 : XCHIP1
(::capPdfUtil::printPdf) Annotating page objects for XCHIP1 : XCHIP1
(::capPdfUtil::printPdf) Annotating page objects for XCHIP1 : XCHIP1
(::capPdfUtil::printPdf) Annotating page objects for XCHIP1 : XCHIP1
(::capPdfUtil::printPdf) Generating PDF file from postscript ....
(::capPdfUtil::printPdf) Successful