Hi All,
Using 16.6-S026. Still going up the learning curve on this tool. I'm modifying a schematic that was generated by someone else.
My problem is that when I try to add a component from the reflib, not all components are available (saw_rx_single). I opened
part developer for this part and got this message:
Cell 'saw_rx_single' : For logical part SAW_RX_SINGLE, pack type LCC is missing in chips.prt but present in the part table file. The default package will be assigned in chips.prt during packaging. If this is not desired, specify the pack type on the General page of the Package Editor.
I couldn't see a problem in the chips.prt file. In the part table file the PACK_TYPE column is empty. How can I fix this?
Thanks!
Bob