Copper Pours

I am still a noob when it comes to the PCB portion of Orcad.  I have a 4 layer board and am ready to make the pours for the ground/power planes.  How is this done properly?  I have done:

1. set a "keep in" rectangle inset in from the board outline.
2. Add: Frectangle on the ground layer
3. Select the "0" net

However, when I do this, all of my through holes give me a DRC error: Thru Pin to Shape Spacing

I also get an error for the keep in layer: Shape to Route Keepin Spacing