Intertool communications

When I pick a part in editor, it does not highlight in Capture. I have intertool comm enabled, I have opened and closed editor and capture and regenerated the netlist.

I'm expecting that when I move R1 in Editor, R1 will highlight in Capture.......... right?

I have witnessed placing parts from Capture also. If I do a series of key clicks between Editor and Capture on an open area in editor and a part in Capture (I have yet to figure out the exact series because it keeps changing) then I can highlight a part from capture, but still need to click on it to place it in editor.

Here is what I'm looking for, when I select a part to place or move in Editor, I would like the corresponding part to be selected in Capture.

I would also like to be able to click on a part in Capture and the corresponding part be attached to my cursor in Editor.

What am I doing wrong...........

 Thanks,

 Tom