Hi,
When creating a part I add the place bound, I suspect most people do that. In order to see them during the design, I also have to add the Place Bounds in the Artwork film set up, so that I see them in the Views tool. So far so good.
But when creating the gerbers, those place bounds are there, shorting nets. So I manually have to go remove them from the Artwork film set up... And if I need to do some modifications to the design, I have to go back and add them again.
One way to solve this would be to display the place bounds only when looking at the top (or bottom) layers. But then I would have to do it every time.
This is counterproductive. There must be a better way. What is it??