Hello,
I guess it was alrady explained in another thread, but I couldnt find any Search button here, so I will ask again.
I am trying to convert schema from old orcad (.SCH) to new capture (.DSN). All goes well till the end, where it throws error:
*** Translating Page 'H:\TEMP\ELDRCP21.SCH' ***
Converting 16-bit schematic 'H:\TEMP\ELDRCP21.SCH' to 32-bit schematic 'C:\USERS\SKOCH\APPDATA\LOCAL\TEMP\ELDRCP21.SCH'...
INFO(ORCAP-39064): Conversion complete.
Cleaning up 'C:\USERS\SKOCH\APPDATA\LOCAL\TEMP\ELDRCP21.SCH'...
WARNING(ORCAP-39027): Cleanup Schematic
Non-Orthogonal Wires/Buses found, need to be checked.
INFO(ORCAP-39067): Cleanup complete.
Could not find H:\TEMP\ELDRCP21.OLB
ERROR(ORCAP-21096): Cannot find part 'G' at 11.30, 8.90.
ERROR(ORCAP-21102): Translation failed.
ERROR(ORCAP-21103): Translation Notice.
Error(s) encountered. Please check the Session Log.
===================
Where G is not a g-spot but a symbol for GND.
What should I do to get rid of this problem?
Is there some list of those ORCAP messages?
Thanks for any valuable help