Quantcast
Channel: Cadence PCB Design Forum
Viewing all articles
Browse latest Browse all 5525

Correct specific rotation angle...again

$
0
0

In Allegro/Orcad PCB standard, 16.6 S064 have the following annoying problem: Have number of components which I left in previous PCB version in fraction rotation angles rotation: 269.996 degrees (90.003 / 0.005 / etc. - because probably I've done spin with cursor at 0 deg. rotation). I simly cannot Zero this fractional angle!

It is like 20 components from 200, but it is annoyng, especially for manufacturing. I try to resolve this by selecting component Move/Spin/Rotate, choosing Absolute / 270 / Body center and all possible combinations of Absolute/Relative and different rotation points, and even "iangle" in command prompt, but without success. Done this in General Edit or Placement mode. Only way to fix this currently is to unplace component and when place it again fractional part is reset. But it takes a lot of time.

It is either I am doing this wrong or I missing something into rotation concept.Obviosly I cannot also move the component to any specific angle - it always stays on 'moved angle.fractional angle'. Any advice or specific command I can use? Can it be something from design parameters, etc.?

Thanks in advance - I am asking this question for second time, and first time left the board as it was, but now there will be new revision, so I want to finally fix it and learn how to do this. Or place/unplace all these components and route them again.


Viewing all articles
Browse latest Browse all 5525

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>