Terminating net on pin

Hello,

I would like to know if there's any option to see a junction point when terminating a net on a pin of a part.

In older versions of Orcad it was done by default, but for what I see in Capture 16 it's only done when THREE nets are terminated on a pin, but not when only two nets are terminated on the pin. You can't place a junction point manually there neither.

Something related with this is shown as a plus in the Capture Cis technical Brief:

CONNECTIVITY RESOLUTION

• Get visual confirmation when terminating nets on pins
• Automatically create or delete junction points using manual override

Thank you in advance.