Greetings,
1. I have a self-made 4-pin connector by went through padstack design steps. ALso I have used "shape add" created a ground plane. How could I connect one of the pins to this ground plane? I'd like directly connect the pin to this plane without thermal relief.
2. Start from a surface mount pin or a through hole pin, I use "add connect (F3)" start drawing wire, then I want to end this wire as it is connected to ground plane which is created by using "shape add" . How to do this?
3. How to place a via that connect to the "shape add" plane (right-side picture)?
I know these are not cutting-edge problems but for a beginner I am looking for simple steps and answers. The HOW-TO videos on youtube are helpful but not for beginners.
Any help will be appreciated.
Thanks
Cheng