I'm familiar with OrCAD Capture 15.7 from a previous job, where creating heterogeneous parts was simple, and placing them on a schematic was no issue. Now, at a new employer, Design Entry HDL is used. There is an extensive library developed at this new position, and I would like to use a part with three sections, however I can not figure out how to place each section (3x32 connector, each row of pins is a separate section of the symbol: Section 1 is A1-A32, Section 2 is B1-B32, etc.)
After exploring the help documentation and tutorials, I still can not figure out a way to place this schematic so that I see J1A, J1B, J1C as I would in OrCAD Capture. Can anyone point me in the right direction?