I'm familiar with OrCAD Capture 15.7 from a previous job, where creating heterogeneous parts was simple, and placing them on a schematic was no issue. Now, at a new employer, Design Entry HDL is used. There is an extensive library developed at this new position, and I would like to use a part with three symbols, however I can not figure out how to place each individual symbol (3x32 connector, each row of pins is a separate symbol of the part: Symbol1 is A1-A32, Symbol 2 is B1-B32, etc.)
After exploring the help documentation and tutorials, I still can not figure out a way to place this schematic so that I see J1A, J1B, J1C as I would in OrCAD Capture. Can anyone point me in the right direction?