Hi there,
I am working on a schematic of a new PCB that I am designing. I am fairly new to PCB Editor, and am using Capture for the schematics. There's a part that I am using (a 200-pin connector) which is a card-edge connector. I haven't been able to find a footprint for it online, so I went ahead and created my own. However, after assigning this footprint to the part, I get the warning message: "Symbol not found in PSMPATH or must be "dbdoctor"ed."
I know this is a duplicate issue, but I have already tried the solutions on the other ones (ran DB Doctor and it finished with no errors, but that didn't fix my problem when generating a netlist). I was wondering if maybe there's something wrong with my footprint. This is my first post on this Blog, and so am not sure what the protocol is.
I am attaching the footprint that I built, along with the connector it should mount on. If any relevant information is missing, or if I can clarify anything else, please let me know.
Note: I am using Cadence 17.2
Thank you. community.cadence.com/.../NG_5F00_CD_5F00_1473006_5F00_M2_2D00_1239382.pdfcommunity.cadence.com/.../1827341_2D00_4_2D00_2.zip