Hi,
I am new to OrCAD software and PCB design in general. I have a simple board I would like to design with multiple etch layers (i.e. top, layer2, bottom, all routing layers).
When I use the board wizard I can see all layers on the visibility tab (top, layer2, bottom) and am even able to use vias to route traces between all layers. However, when I use capture to
generate a netlist and open it with my board, the inner layers disappear from the visibility tab. When using auto-routing only the top and bottom layers are used.
Would anyone be able to advise on why I am unable to see/use all the layers I originally made with my board?
Thank you in advance for any assistance.