Hey all,
I've been posting here for a few months now, and would not have gotten as far as I had without the community here. I am just about ready to send the board off for prototype when I noticed I have a rats nest on one on the FPGA pins. This wasn't on the original board design, and I didn't go anywhere near this part of the board when making my edits.
My question is, what are my options here? It will not let me simply make a trace to the two points. This is a top-bottom rats nest as well if that helps.
When I select Display/Show Rats/Nets, the highlighted parts appear identical, and the connections on the original board file appear the same as the new (at least in the area that I'm seeing the rats nest.).
Stumped...
Orcad Top
Real World Top
Real World Bottom