Hello.
I'm working on Orcad 16.6.
Due to a operator error we built a pad PTH (60mil copper with 39mil hole) NOT PLATED.
In Pad Designer this pad passes the check. No errors.
We built the symbol (HEADER 4x1 2.54mm). No errors.
Now we are working on a 4 layer board with this symbol.
We routed some net from inner layers to outer layer on this symbol.
We completed the board. No errors. All lights green on status.
With DFM analysis on ODB++ file we found broken nets on the header (correct because it's unplated)
Why Orcad PCB says all is ok. All green?????
With Mentor and Altium if there's a pth component with unplated pin you can't complete the connectivity
Thank you
Stefano