Hi all.
In Allegro/Orcad does anyone know if some skill code exists that would make enabling/disabling ratsnest guides/lines more dynamic ?
In the Specctra route editor I find it far easier to use to enable disable nets than in Allegro.
For example in Specctra you can simply click a pin or window select a component and the rats show up. If you window select a component or pin again that is showing the ratsnest then the ratsnest turns off.
This works great and has been that way for years in Specctra.
Over on the Allegro side of things you have to do two operations basically enable, disable. For example "Show Rats Net" & "Blank Rats Nets"
The dual operation is really tiresome, too many clicks IMHO.
Ideally what I am after is basically a toggle for the ratsnest. Click the pin and the rat appears, click the pin again and it disappears.
It is doable with hot keys but I have too many already assigned
Thanks.