Hi All
I tried to check the all connected pins with signal command of RMB
right block is Reused Hierachical block imported by OLB
the Hierachical block property has the path which is the location of original DSN
and I place the part with OLB (see below right)
you can see the 2 thick lines which is upper one is bus and lower one is netgroup
I can see all connected pins included inside of Hierachical block with clicking the lists
but despite the hierachical block is connected, I can't see the lists which is connected by Netgroup
it only show the current page connected state
Doen't it unable to see with netgroup all connected pins?
소중한