Hi All
there is thin trace which is connected to Via or Thru-Pin which have Anti-pad area.
but the thin trace should be fatten when it enters on Anti-pad Area like below.
Can I control the thinkness of trace in Anti-pad area?
of course if I lay the shape it would be done, but there are so many via or thru-pin should be applied like this.
so I need the function to fatten trace automatically
I want to make all trace like below automatically when they get in the anti-pad area.
below one is that I made manually with cut the single Cline segment
(without Taper/Tear drop)
regard