Updated to the latest service pack and I'm seeing a problem I have not run into before. Maybe I'm doing something wrong, but....
Below picture shows pairs of pins routed out to vias on the top layer. After laying these pairs down I now want to continue routing from the via on the bottom layer. I set my active layer to the bottom and click on the ratsnest near the via and my cursor jumps back to the IC pin and wants to route on the top layer. No matter what I try, I can not route from the via. It is sending me back to the IC pin. I have done this numerous times in the past and I'm wondering if it is a "feature" (bug) in the latest release, or is there some setting that I don't have set properly?
Tom