Hi every one
I have design with 2 BOM warians where two symbols from different BOM variants overlapped each other :
this is 4-port rj45 connector and 1-port rj45 connector
The problem is that I can not complete rattsnest on the same pads.
It seems routing etches automatically deleted from second component : after any routing i try to move 1-port connector with option "slide etch" and i see there is no etches on them, EVEN i select right pad before routing using tab button.
How can i solve this?
If there any checkbox in Cadence options that tells that if etch vertex is located inside pad area, that connection marked as routed?