Once in a while I have a need to create a single sided layout. In 16.6, I was able to click “Modify design padstack- all instances” to switch pads over to non-plated holes. Now in 17.2 (S031) you can’t toggle to the unplated option. Even thou there is a pull down arrow to do so. So now my drill chart continues to read plated for a non-plated design. This confuses the suppliers unless I add a note stating holes for the design shall be un-plated. I have no need to build a separate pad stack library to support single sided designs because they are so uncommon for us. It is much easier to just change the setting in the design. I suspect that is a bug due to the re-write of the padstack utility. Please confirm or advise.
Cheers