Hello I have these Unrouted connections. These are all the 0 (or gnd) pin of various components an I will connect all these to the Ground (I will have a ground plane - Dynamic copper on the top).
Is there any actual problem occurring from this situation? I mean, I intend to ignore these warnings. Will the final gerber files have any malfunctioning? Will this affect production?
Also I did not find anything relative to this in the Documentation - maybe I did not search deep enough, any point where I should look?
-> Allegro ver.17.2
Thanks alot!
Regards,
Andreas
Image may be NSFW.
Clik here to view.
Clik here to view.
