Hi guys just a few questions, perhaps you can offer insight on how you are doing this.
In etch edit mode when I route multiple traces at the same time is there any way to gather the traces so that the spacing of the traces get tapered down or pulled closer together as I continue routing.
When adding vias in multi route mode is it possible to stagger the vias when I switch from the top layer to the bottom layer of the board.
I know these handy features are in the full blown allegro package but they do not appear to be in the Orcad level of the tool. Was wondering if there is any way to take some of the heavy lifting out of routing traces manually in Orcad pro. Seems like the ability to gather traces or stagger vias should be standard by default.
Thoughts ?
Thanks Scott